MATERIALS & COLORS 54 www . b j s p a r k .com · 1-800- 3 9 2 - 6 1 5 8 Our recycled plastic material is 100% recycled high-density polyethylene and is formed using a combination of post-consumer and post-industrial waste plastics. There is no virgin plastic in this product. Post-consumer plastic has been used by a consumer and then recycled to avoid dumping in a landfill (such as milk jugs). Post-industrial plastics have gone through a manufacturing process but never reached the consumer (such as product rejects or process wastes). On average our product is 80% post consumer and 20% post industrial (percentages can vary). Our plastic components are 100% recycled and can also be recycled again and again. There are no toxic chemicals in this product. Plastic by its very nature does not leach. A solid color is formed throughout the component and a UV stabilizer is added for ultraviolet protection. This recycled plastic is a dense, durable product, offering a long lasting, attractive appearance. It will not splinter or rot, and is resistant to mold and insects. These components are molded into solid dimensional shapes corresponding to nominal lumber dimensions. Recycled plastic components are available in your choice of colors. Model No. Example for Recycled Plastic products: PCXB/G-4♦24 Replace (♦) with letters indicating color choice listed under sample. Blue Use PU in model no. Weathered Wood Use PD in model no. Cedar Use PC in model no. Green Use PN in model no. Gray Use PA in model no. Brown Use PW in model no. 100% RECYCLED PLASTIC - Timbers, Planks and Frames Note: Custom colors and textures may be available when ordered in sufficient quantity and additional production lead times. Red Use PR in model no. Yellow Use PY in model no. Black Use PB in model no. Our recycled plastic lumber is extremely chemical resistant to very harsh chemical removers. There are several graffiti removal tools on the market that could be used on our plastic lumber. Harsh graffiti removers like MEK, NexGen, and Gasoline solutions will not harm the plastic lumber. Be sure to wash off any residue. Pressure washing, with detergent added, will remove most dirt, grime, markings, and debris. When pressure washing, start with the tip far away, and then gradually move closer to the plastic lumber to avoid gouging the plastic lumber with too aggressive of a pressure wash. If the substance is ground in, oily or sticky; some type of solution will be needed to loosen up the stain to get it out of the textured surface of the plastic lumber. GRAFFITI REMOVAL SUGGESTIONS ALUMINUM Several select picnic tables and benches can be equipped with seats/top or seat/back of aluminum planks. These planks are extruded 6063-T6 aluminum, equivalent in size to 2" x 10" (nominal) lumber planks. Four structural ribs provide rigid support and strength. The aluminum is clear anodized to specification 204 R1 for a clean, maintenance free finish. All plank ends are covered by an extruded, clear anodized aluminum end cap fastened into place. Table tops are made into single units (at the factory) by connecting the planks with one-piece end caps fastened across each end of the top. Aluminum planks are provided with precision fitted aluminum brackets and galvanized carriage bolts to attach planks to table or bench frames. Use "AL" in model number for clear anodized aluminum, e.g. XT/G-6AL. Optional: Aluminum (mill finish) components (max. 12 ft. length) are also available with powder coated finish. See Powder Coat Finish description for details. Note: Colors and textures may vary. Colors shown are as close to the actual colors as the printing process is able to reproduce them. When selecting colors, keep in mind that Thermo-plastic Coating, Powder Coating and Recycled Plastic may not be exactly the same color -- i.e., Blue Thermo-plastic Coating for seats and/or table tops and Blue Powder Coating for frames may differ slightly.
RkJQdWJsaXNoZXIy NTkzMzk=